Read this first. We are not the authority having jurisdiction. Each city's building office decides what it requires, and requirements, forms and fees change. Everything below was checked against official pages on October 4, 2026. Confirm with the office before you apply.
Does an EV charger need a permit?
Yes, in every city we serve. A Level 2 charger runs on a new 240-volt circuit, and each city treats new or altered electrical circuits as permitted work. The permit gets the circuit inspected against Utah's adopted electrical code, which is the 2023 National Electrical Code. The question is not whether, but which office and which form.
Start with the address, not the city name on your mail. Ogden's permit page asks applicants to verify that an address is inside Ogden City using the Weber County GIS map, and the same check matters in North Ogden and the Ogden Valley, where county parcels and the new city boundary make mailing names unreliable.
| Jurisdiction | Portal | Form for an EV circuit | Phone |
|---|---|---|---|
| Ogden City | EnerGov Self Service | Residential Electrical | 801-629-8950 |
| South Ogden | iWorQ | Building Permit, Permit Type "Electrical" | 801-622-2913 |
| North Ogden | iWorQ | Check with North Ogden Building | 801-737-9837 |
| Ogden Valley City (Eden, Liberty) | City Inspect | Electrical Permit (Residential) | 801-726-1606 |
| Unincorporated Weber County | OpenGov | Not reviewed | 801-399-8770 |
Ogden City
Ogden's permit requirements page reads: "A permit is required for an electrical, natural gas, mechanical, or plumbing system for the following: Alter, Change, Extend, Install, Repair, Replace". A charger circuit is a new installation, so it applies. Apply in the city's EnerGov Self Service portal under the Residential Electrical permit type.
Who may apply. Ogden's FAQ says: "Commercial and all residential rentals: Utah State licensed contractor only. Residential (owner-occupied): Homeowner or Utah State licensed contractor." So a landlord adding a charger at a rental needs a licensed contractor.
Fees. Ogden charges building, electrical and similar permits by project valuation. The fee table in Ordinance 2024-14, adopted May 7, 2024, sets these bands:
| Project valuation | Base fee |
|---|---|
| $1 to $1,200 | $70.50 |
| $1,201 to $2,000 | $70.50 plus $2.78 for each additional $100 or fraction |
| $2,001 to $25,000 | $92.75 plus $16.00 for each additional $1,000 or fraction |
Plan review, where it applies, is 65 percent of the base fee or the actual review cost if less; over-the-counter review is $47.00. This is the May 2024 ordinance text. Later amendments were not checked, so confirm the current fee with the city. The city's permit page separately lists a $70.50 deposit due when an application is accepted, credited against the final fee.
Timing and inspections. The city says to allow one to three days to process applications. Inspections are scheduled at 801-629-8950. Its inspection basics: "Address posted on site; Approved plans on site; Ladder on site for attic and roof access; Open and accessible."
Historic districts. Ogden has three local historic districts: 25th Street, Eccles and Jefferson. A Certificate of Historic Appropriateness from the Landmarks Commission is required before any permit is issued for work that affects a property on the Ogden City Register, and "work" includes alterations. The commission's published policies do not mention EV chargers, so ask Ogden Planning at 801-629-8930 whether an exterior-mounted charger, conduit or pedestal on a registered property needs a certificate before applying.
South Ogden
South Ogden requires a permit to "erect, install, enlarge, alter, repair, remove, convert or replace any electrical" system. Apply through the city's iWorQ portal on its single Building Permit form, choosing "Electrical" as the permit type. There is no EV-specific option. Utah-licensed contractors, or homeowners working on their own primary residence, may apply.
The form asks for a project cost and a project description, and accepts uploads in PDF format only. Inspections are scheduled by calling 801-622-2913 with the permit number; the city takes inspection calls 9 a.m. to 3 p.m. with 24 hours' notice. No fee schedule was published on the pages we reviewed.
One discrepancy to know about: South Ogden's building FAQ says the city enforces the 2021 edition of the National Electrical Code, while state law (Utah Code 15A-2-103) adopts the 2023 edition statewide. The FAQ may simply be out of date. If a detail depends on the edition, ask the building official.
North Ogden
North Ogden permits electrical work through its iWorQ portal, but do not use the Electrical Upgrade Permit form: it states it is "NOT Solar, EV Chargers, or Generators." Which form an EV charger should use is not stated online, so call North Ogden Building at 801-737-9837 before applying. The city says applications are reviewed the same day they are submitted.
Inspections are requested online from the permit record.
Fees. North Ogden's Resolution 05-2026 consolidated fee schedule, effective May 13, 2026, bases residential permit fees on the 1997 Uniform Building Code Table 1A plus 20 percent, with a $56.40 minimum permit fee, a $56.40 re-inspection fee, single-family plan check at 50 percent of the permit fee and a state fee of 1 percent. It also lists a $500 residential plan check deposit; ask North Ogden Building whether it applies to a stand-alone charger circuit.
Check the address. North Ogden's General Plan says the Coldwater and Southtown neighborhoods contain unincorporated Weber County parcels. Those addresses are permitted by the county, not the city.
Eden and Ogden Valley City
Eden, Liberty and Wolf Creek addresses are now permitted by Ogden Valley City, which incorporated in December 2025. Weber County's building page sends those projects to the new city. Its Electrical Permit (Residential) requires an electrical diagram of the scope of work, the manufacturer's equipment specifications and a project valuation including materials and labor.
Applications go through the City Inspect portal. Plan review and inspections are contracted to Beacon; schedule inspections by call or text at 801-564-0897. No fee schedule was published. Huntsville town is separate, and Powder Mountain is outside the city. Local details are on the Eden EV charger installation page.
Unincorporated Weber County
Addresses outside any city, such as the county pockets near North Ogden and Uintah Highlands south of South Ogden, are permitted by Weber County Building Inspection. Since March 30, 2026, new applications go through the county's OpenGov portal. The county allows up to fourteen working days for plan review and schedules inspections within three business days.
Do you need to tell Rocky Mountain Power?
If the install needs a service or meter upgrade, yes: Rocky Mountain Power asks you to call 1-888-221-7070 to request it. Its tariff also asks customers to give written notice before "any substantial additions or changes" to their electrical facilities, without defining substantial. Whether one home charger on an adequate service counts is not spelled out.
The full sentence in Electric Service Regulation No. 5, section 2(b), reads: "Prior to the Customer making any substantial additions or changes in his/her electrical facilities, either in size or character, the Customer shall give the Company written notice of this fact." The utility's electric service requirements for EV charging tell one- and two-family homeowners to determine whether their service is adequate, note that "a service panel upgrade may be required," and say to contact the company for more information. Workplace and multifamily sites must give the utility the expected new load and charging frequency.
Rocky Mountain Power's EV page adds: "If an electrical contractor is hired to perform the work, it is the homeowner's responsibility to ensure the appropriate permits are obtained."
How the permit fits into an install
We apply for the permit in the correct jurisdiction, include the charger's specification sheet, and schedule the inspection after the work is done. Whoever applies, the steps are the same: confirm the jurisdiction from the address, submit the application with the charger's specifications, do the work, then pass inspection. For the bigger picture on local rates and incentives, see the Ogden EV charging guide, and for the install itself, home EV charger installation.
EV charger permit questions
Do I need a permit to install an EV charger in Ogden?
Yes. A Level 2 charger needs a new 240-volt circuit, and Ogden City requires a permit to install, alter, change, extend, repair or replace an electrical system. The permit is the Residential Electrical type in the city's EnerGov portal. South Ogden, North Ogden and Ogden Valley City have similar rules for electrical work.
Can a homeowner pull their own EV charger permit?
In Ogden, yes, if you live in the home: owner-occupied residential permits may be pulled by the homeowner or a Utah-licensed contractor. Rentals and commercial work need a licensed contractor. South Ogden allows homeowners on their own primary residence. In every city the work still has to pass inspection.
How much is an EV charger permit in Ogden?
Ogden sets permit fees by project valuation. Under the fee table in Ordinance 2024-14, valuations up to $1,200 pay $70.50, and the city collects a $70.50 deposit when an application is accepted. Larger valuations add a set amount per $100 or $1,000. Confirm the current fee with the city before you budget.
Do I need a permit to plug a charger into an existing outlet?
Using an outlet that already exists is not one of the actions Ogden lists: alter, change, extend, install, repair or replace. Adding or replacing an outlet, changing a breaker or running a new circuit is, and that needs the permit. If you are unsure whether an existing outlet is suitable for hours of continuous charging, have an electrician look at it.
What happens at the EV charger inspection?
An inspector checks the circuit against the adopted code: breaker size, wire size, protection, mounting and labeling. Ogden lists electrical wiring, conduit and final inspections among its typical inspections, and asks that the address be posted and the work be open and accessible. Failed items are corrected and re-inspected.
Not sure which office covers your address? Send it with your car model and a panel photo.
Get a permitted install quote